![]() ![]() For testing purposes manually mounting is enough. With the following commands you will mount an SMB share into /mnt/smb and an NFS share into /mnt/nfs. Just play around and find the configuration which meets your requirements.Ĭreate folders inside /mnt (e.g. The upper hosts might get read access whereas the lower hosts might get additionally write access. You might split your network segment into two regions. As you can see below I have restricted read and write access to the network segment 10.10.0.0/24, which allows the access to a total amount of 254 hosts. Since NFSv4 it’s possible to use a Kerberos server, which extends the authentication system.Įnabling NFS and SMB in a Synology NAS (DSM) is done with a few clicks. However SMB provides a user-based authentication. This means that every user on an authenticated machine can access a specific share. NFS uses the host-based authentication system. An important difference between both protocols is the way they authenticate. I have decided to use NFSv4 and SMBv2 with large MTU. The bit rate between PC and FritzBox is set to 100 Mbit/s. The NAS device is linked to FritzBox with 1000 Mbit/s. ![]() It has a hard disk with a transfer rate of around 150 MB/s. The NAS device will be the target for read and write operations. I will show you a basic benchmark based on read and write operations with both protocols. Since SMB is supported by Windows, many company and home networks use it by default. Without user confirmation.Both SMB and NFS are network protocols of the application layer, used mainly for accessing files over the network. This command specifies the encryption ciphers used by the SMB client, and the preferred order Example 6: Specify encryption ciphers Set-SmbServerConfiguration -EncryptionCiphers "AES_128_GCM, AES_256_GCM" -Confirm:$false This command disables SMB1 on the SMB server without user confirmation. Example 5: Turn off SMB1 Set-SmbServerConfiguration -EnableSMB1Protocol $false -Confirm:$false This command turns off server announcements without user confirmation. Example 4: Turn off server announcements Set-SmbServerConfiguration -ServerHidden $false -AnnounceServer $false -Confirm:$false This command turns off the default server and workstations shares without user confirmation. Example 3: Turn off the default server and workstations shares Set-SmbServerConfiguration -AutoShareServer $false -AutoShareWorkstation $false -Confirm:$false Splatting to pass parameter values from the $Parameters variable to the command. Set-SmbServerConfiguration command turns on SMB signing and encryption without user confirmation. Example 2: Turn on SMB signing and encryption $Parameters = $true This command sets the SMB Service configuration without user confirmation. Systems ( KB5016693), and Cumulative Update forĮxamples Example 1: Set the SMB Service configuration Set-SmbServerConfiguration -MaxChannelPerSession 16 -Confirm:$false The DisableCompression and RequestCompression parameters are available beginning withĢ022-08 Cumulative Update for Microsoft server operating system version 21H2 for 圆4-based ( KB5014665), and Cumulative Update for Windows 11, Microsoft server operating system version 21H2 for 圆4-based Systems The EncryptionCiphers parameter is available beginning with 2022-06 Cumulative Update for Overview of file sharing using the SMB 3 protocol in Windows ServerĪnd :Server Message Block (SMB) Protocol Versions 2 and 3. The Set-SmbServerConfiguration cmdlet sets the Server Message Block (SMB) Service configuration.įor more information on SMB server and protocol specifications, see In this article Syntax Set-Smb Server Configuration Sets the Server Message Block (SMB) server configuration. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |